The normal operation of the equipment can only be ensured by operating the vibrating screen in accordance with the correct safety regulations during the use of the vibrating screen. Today, the vibrating screen manufacturer will introduce to you the safety operation regulations of the high-frequency dewatering vibrating screen that we need to abide by!

Precautions for the installation of high-frequency dewatering vibrating screen

Linear vibrating screen

(1) When the vibration exciter is installed and repaired, it shall not be beaten hard or have a different phenomenon, and ensure that the original bearing is used and shall not be interchanged.

(2) The thickness and quantity of the eccentric block or counterweight plate attached to the eccentric block must be the same, and the radial clearance of the bearing should be C3 grade.

(3) The connection between the universal joint and the vibration exciters on both sides must be concentric, the eccentric blocks on both sides are in the free plumb position, and the universal joint connecting bolts can pass through smoothly; if there is any deviation during installation, check the universal joint Whether the joints at both ends of the section are concentric, do not swing the eccentric block angle for installation.

(4) The vibrating screen should be installed with springs with the same stiffness. The spring stiffness on both sides of the feeding end and the discharging end should be as consistent as possible, and the allowable height difference does not exceed 3mm.

(5) Both sides of the support seat of the rubber spring of the vibrating screen should be in the same horizontal plane, and the error is between 2-4mm to ensure that the materials on the screen surface advance evenly.

(6) When using electric welding to install or disassemble parts, the ground wire must be directly fixed on the welded workpiece and as close as possible to the welding point, and the welding current must not pass through any bearings or joints.

(7) In principle, welding should not be performed on the side plate. Depending on the current environment, if connecting components are required, the side plate should be drilled and then connected with bolts.

(8) The universal joint must be concentric, and a protective device must be installed to prevent it from breaking and falling and hurting people.

Precautions for the use of high frequency vibrating screen

High frequency dehydration vibrating screen

1. Understand equipment related knowledge

The operator should ensure that the operator understands the scope of use and technical performance parameters of the equipment; has sufficient understanding and mastery of the structure, principle and common sense of maintenance of the equipment; familiar with the process flow and equipment control of the system; keep in mind the high-frequency vibrating screen Safe operating procedures.

Details can be accessed by clicking here:https://www.hsd-industry.com/news/safety-operation-rules-for-high-frequency-dewatering-vibrating-screen/