Calcium hydroxide equipment is mainly used to produce calcium hydroxide and other chemical products, and almost the entire production is carried out on this equipment. When feeding, you must pay attention to the relevant requirements, and there are also many things to pay attention to.

PRECAUTIONS WHEN FEEDING CALCIUM HYDROXIDE EQUIPMENT

1. The calcium hydroxide equipment cannot meet the classification requirements of micropowder in the cement grinding system, mainly because the specific gravity of the micropowder is much smaller than that of the cement, so the equipment has a weak ability to identify the micropowder.

2. When entering the negative pressure operation, the grinding material is fed from the inlet of the calcium hydroxide equipment of the distributor, and meets the vortex airflow entering the primary air outlet. After being fully dispersed by the suspension dispersing mechanism, the fine powder enters the grading area through the secondary air outlet in the airflow. The resulting horizontal vortex field is graded.

calcium hydroxide equipment

3. The discharge temperature is controlled at about 45 degrees Celsius, and the water content of the discharge is controlled at about 1%. In this way, the agglomeration of finished products is prevented, and the efficiency of powder selection and the waste of slag discharge are improved.

4. The fine powder enters the rotating cage, and the negative pressure air is pumped into the subsequent dust collector from the fine powder outlet, and the finished product is collected by the dust collector. The coarse powder falls into the cone, is discharged through the coarse powder outlet, and returns to the mill for grinding again.

Details can be accessed by clicking here:https://www.ly-gaifeng.com/blog/cautions-for-feeding-calcium-hydroxide-equipment.html